![]() ![]() (Snap to the intersection of the lines for the base point) (Figure Step 9) Figure Step 9 Step 10Įnter the COPY command, as shown below, to copy the circle and hexagon 4 times. Change the layer of the line you just created to layer: Construction. Using the OFFSET command, offset the left line of the rectangle 1.5 inches to the right. Using these principles in the your day-to-day work will noticeably increase your productivity.ĪUTHOR’S COMMENTS: There should be a total of 9 construction lines, 1 inch apart. ![]() If an object has to be drawn that is similar to one that was previously drawn, simply copy it and change it. In AutoCAD, objects only have to be drawn once and then they can be used over and over again even if they are in a different drawing or at a different size or orientation. Using the MOVE and COPY commands are a big part of that productivity. One of the real benefits of using a CAD program is increasing your design and drawing productivity. Fill out titleblocks in Paper space using the AutoCAD 2D book Standards.Describe how to construct a tangent arc that has one end tangent to a line and other end going through a point.Apply the FILETAB and FILETABCLOSE commands to enable the display of the open drawing file tabs above the Graphic window.Apply the MOVE, COPY, COPYCLIP, PASTECLIP, and COPYBASE commands to move and copy objects in the current drawing plus copy objects from one drawing to another.Describe how to move and copy objects in the current drawing and from one drawing to another.When you have completed this module, you will be able to: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |